Middleby-marshall Oven Manuel d'utilisateur télécharger pdf (Page 14)

2-14

SECTION 2

INSTALLATION

JOINING THE OVEN BODIES

For TANDEM and DOUBLE TANDEM installations, perform

Steps 1-7 to join the ovens.

For TRI TANDEM installations, perform Steps 1-7 to join two of

the ovens together, and ensure that they are level; then, repeat

Steps 1-7 to join the third oven to the two that are assembled.

For QUAD TANDEM installations, perform Steps 1-7 for EACH

PAIR of ovens, producing two sets of two joined ovens. Do not

assemble the center bridge section at this time.

1. Determine the proper position of the ovens by referring to

Figure 2-15. Then, move the ovens to their approximate

final locations.

NOTE: The Sealing Gasket Assembly is shown attached

to the left oven in Figure 2-15, but may be pre-mounted to

EITHER of the two ovens.

2. Remove the rear axial cooling

fans that are adjacent to the

mating sides of the ovens, as

shown in the diagram. Leave

the fan wiring connected to

the oven.

Figure 2-16

Cooling Fan Removal

Mating surface of

ovens (shown

from lower rear)

Wiring is still

connected

Figure 2-15

Oven Positioning and Alignment

Alignment

plate

Slot for

alignment

plate

Sealing gasket

assembly (pre-

mounted)

LEFT OVEN RIGHT OVEN

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Pas de commentaire

Middleby-marshall Oven Manuel d'utilisateur Page 14