Middleby-marshall Oven Manuel d'utilisateur télécharger pdf (Page 23)

2-23

SECTION 2

INSTALLATION

VI. ELECTRICAL CONNECTION

Check the oven data plate before making any electric supply

connections. Electric supply connections must agree with data

on the oven data plate. A typical oven data plate is shown in

Figure 2-34 (on Page 2-24).

NOTE: When the oven is installed, it must be electrically

grounded in accordance with current IEC/CEE requirements

and also with local codes.

The electrical installation, including the service connection,

must comply with current IEC/CEE requirements and to local

codes. The installation must undergo a complete electrical

check before operating the oven.

Special attention must be given to the polarity of the supply

when connecting to oven input terminals.

All connections are made at one common connection at the

back of each oven. Refer to Figures 2-32 and 2-33.

NOTE: At the installation location, it is required that the

electrical supply for each oven incorporates a main circuit

breaker (not furnished). The circuit breaker must have 3mm

contact gaps breaking all poles of the supply.

WARNING: If your electrical supply has fast-acting circuit

breakers, then the initial starting current of the blower motors

in Model PS360WB-U and PS360WB-L may trip the breakers.

It is suggested to use slow-acting circuit breakers with these

models.

For further electrical information, refer to the wiring diagram.

WARNING: The connections to the exhaust system, electrical

supply, and gas supply must follow the installation instructions.

Initial start-up of the oven can be performed only by an

authorized agent.

Figure 2-32

Junction Connection Box (Lower Oven)

Figure 2-33

Junction Connection Box (Upper Oven)

3/4 (19mm) pipe for gas oven connection

3/4 (19mm) pipe for gas

oven connection

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

Pas de commentaire

Middleby-marshall Oven Manuel d'utilisateur Page 23